Regulated Switchmode AC-DC Power Supply AC Adaptor
Category
ICT/ITE Power Supply
Input Voltage Range (V)
100-240V~, 50-60 Hz
Max Input Current (A)
1.5A
Max Output Power Rating (W)
60
Output Voltage Range (V)
12-48
Efficiency
V
Ingress Protection
IPX0, IPx1 or higher available
Size (mm)
47*114*32.4
Enclosure
Rating Table
Model Number (Final ordering #/Part No to be defined)
Voltage (V)
Current (A)
Power (W)
RFQ
GT-41132-6012-T2*
12
5
60
GT-41132-6013-1.0-T2*
12
5
60
GT-41132-6027-12.0-T2*
15
4
60
GT-41132-6026-8.0-T2*
18
3.33
59.94
GT-41132-6526-7.0-T2*
19
3.42
64.98
GT-41132-6526-2.0-T2*
24
2.7
64.8
GT-41132-6048-T2*
48
1.25
60
* (Final ordering #/Part No to be defined)
Specifications
A) ELECTRICAL SPECIFICATIONS: 01. Input Voltage: Specified 90-264 Vac, Nameplate rated: 100-240Vac 02. Input Frequency: Specified 47-63 Hz, Nameplate rated 50-60Hz 03. Output Regulation: +/- 5% measured at the output connector 04. Line Voltage Regulation: +/- 1% typical measured at output connector 05. Output Ripple (Vp-p): +/-1% or 150 mV whichever is greater, measured at 20 MHz bandwidth with 0.1 uf ceramic capacitor in parallel with 10 uf electrolytic capacitor connected at the end of the output connector at nominal line 06. Turn-ON/OFF Overshoot: 5% maximum, 1 mS typical recovery time for 25% to 50% step load 07. Turn-ON Delay: 1 Second Typical 08. Hold-Up Time: 8 mS typical @ nominal input voltage and full load 09. Inrush Current: 30/60A maximum cold start @ 115/230 Vac input 10. Switching Frequency: 65 KHz typical
B) PROTECTION 01. Over-Voltage: Electronically Protected Zener clamp across the output 02. Short Circuit: Electronically Protected unit will auto recover upon removal of fault 03. Input Protection: Input line fusing
C) SAFETY 01. Dielectric Withstand Voltage: 4242Vdc from primary to secondary 02. Touch Current: <0.25mA @ 240Vac input voltage
D) OTHER: 01. MTBF: 200,000 Hours @ 25°C ambient temperature 02. Operating Temperature: 0°C to 40°C ambient temperature 03. Humidity: 0% to 90% relative humidity 04. Storage Temperature: -10°C to 80°C 05. Cooling: Convection 06. ROHS 2: Complies with EU 2011/65/EU and China SJ/T 11363-2006
E) ENCLOSURE 01. Housing: High impact plastic, 94V0 polycarbonate, non-vented 02. Size: 47*114*32.4 +/-1.0 mm 03. Markings: Label and/or Pad Printed and/or Molded in the case 04. ROHS 2: Complies with EU 2011/65/EU and China SJ/T 11363-2006
Derating Curve
Qty (ea.)/Carton
60
Individual Box/Gift Box Size (mm)
60*150*60
Individual Box/Gift Box Color
60*150*60
Master Carton Size (mm)
470 x 323 x 268
Gross Weight (kg)
15.6
Label Width (mm)
39.5
Label Height (mm)
99.5
Input Configuration
Description
IEC 60320/C8 AC Inlet connector, Class II, Non-Earth Ground (aka "Figure-8") Mates with IEC 60320/C7 Plug
Below are standard cordsets which are "not included" (unless stated above); these may be purchased separately or packaged with the power supply. Please contact your Sales Engineer if the style required is not shown below. Many more available in different lengths, colors or cable material.
Contact GlobTek for your specific requirements or custom solutions.
Approvals
Below follows a link to the latest regulatory certifications and marks for this specific product. National standards as well as certification schemes are constantly changing and so is the set of certification marks and symbols applicable to this product. Various standards, marks and symbols, and certificates are subject to change at any time without notice.
Additional standards or unique country certifications are available upon request. Please contact Globtek to request a quotation.
Logo
Description
NOM (Mexico) to NOM-001-SCFI-1993 for GT-41083-4012-T2 GT-41083-4024-9.0-T2 GT-41083-4024-6.0-T2, GT-41083-4024-5.0-T2, GT-41083-4024-4.0-T2, GT-41083-4024-T2 GT-41083-4048-T2
Australia and New Zealand Regulatory Compliance, Mark (http://rcm.standards.org.au/rcmfaq/rcmfaq.htm
UKCA Certification
JAPAN TUV Rheinland-PSE GlobTek Inc to J60950-1(H26) , J55022(H22),J3000(H25).Please follow the procedure listed in the following link for proper import to Japan: https://www.globtek.com/r2/Szj4Vb
CCC to GB4943.1-2011; GB/T9254-2008 GB17625.1-2012, Tropical <2000
CHINA SJ/T 11364-2014, China RoHS Chart: http://www.globtek.com/pdf/F-GT-DJD-8.4.1-006%20China%20RoHS%20Declaration%205-20-22.pdf
NEMKO IEC 60950-1:2005 (Second Edition) + Am 1:2009 + Am 2:2013
Indoor Use Only - Mark is on the label or Molded in the case
Japan: Voluntary Control Council for Interference (VCCI)
GOST-R mark for Russia(Document: http://www.globtek.com/html/iso_certificates/GT_GOST-R.pdf). 03/15/2015. Due to lack of demand, GlobTek will not be renewing it's GOST certification. Please contact your sales engineer for pricing on EAC.
Efficiency: complies to section 301 of Energy Independence and Security Act (EISA) complies with Energy Star tier 2 (North America), ECP tier 2 (China), MEPS tier 2 (Australia), Code of Conduct (Europe)
RoHS
Specifications of directive 2011/65/EU Annex VI (ROHS-2) with amendment 2015/863-EU (ROHS-3) http://www.ce-mark.com/Rohs%20final.pdf
WEEE: Complies with EU 2012/19/EU (http://ec.europa.eu/environment/waste/weee/index_en.htm) Mark is on the label or Molded in the case
No Logo Applicable
CB report to IEC 60950-1(ed.2);am1;am2
LPS
Limited Power Source LPS ((19V,24V & 48V only)
UL cULus LISTED 4MU8 E341351
JAPAN TUV R-PSE, Cert. No. JD 50313287, to J60950-1(H26) , J55022(H22),J3000(H25)[DC15?30V]. Please reference the following website for guidelines on PSE regulations: https://www.globtek.com/r2/Szj4Vb
JAPAN TUV R-PSE, Cert. No. JD 50469658, to J62368-1(H30) , J55032(H29),J3000(H25)[15V or less]. Please reference the following website for guidelines on PSE regulations: https://www.globtek.com/r2/Szj4Vb
JAPAN TUV R-PSE, Cert. No. JD 50313287, to J60950-1(H26) , J55022(H22),J3000(H25)[DC30?60V]. Please reference the following website for guidelines on PSE regulations: https://www.globtek.com/r2/Szj4Vb
CE Mark: tested to comply with EN55022:2006/A1:2007 Class B, EN610003-2, EN610003-3 including EN61000-4-2, EN61000-4-3, EN61000-4-4, EN61000-4-5, EN61000-4-6N EN61000-4-11; EMI: Complies with EN55011 CLASS B and FCC Part 15B - On label or Molded in case