100 Watt Switching Power Supply General Specifications

Rating Table, Modular Concept for Desktop Power Supplies

General Specifications:

85-100Watt Multi-Output W/PFC Module (Standard option) series, SMPS

INPUT
Voltage:		90 - 264 V AC
Frequency:		47 - 63 Hz.

Current:		<2 A

Inrush Current:		<45 A
Protection:		fuse, thermal shutdown

Connector:		EN60 320 /C14/ 3Pin, Class I EN60 320 /C18/ 2Pin, Class II

OUTPUT
Voltage:	Rating table
Current:	Rating table

Regulation	< 5 %
Total Power	100 W Max
Noise & ripple	<1 %
Protection:	Short Ckt, OverLoad,Over Volt
Hold up Time:	20mS min @120 VAC
Connector:	Out Plug/Cord Selection

GENERAL
Size:	142 x 76 x 43 ± 1mm
Encl:	Black Plastic.
Marking:	Standard
Operating Temp:	-10 to +40 C
Storage Temp:	-20 to +85 C
Relative Humidity:	0% to 95% non-condensing
Efficiency:	75 % typical
MTBF:	> 50,000 hours
Approvals :	UL, CUL,TUV,CE
EMC:	FCC Level B, EN55022, EN55011 Class B

Notes:

Output Regulation (line/load): for single output units:
± 5%; for multiple output units: ± 5% for main output, ± 5% for second output and + 10% for third output. (measured at the end of the output connector).
3.3 V units:
Remote sensing is required to achieve specified output regulation.
Output Ripple/noise (Peak-to-Peak):
1% or 100 mV,whichever is smaller, except for +3.3V units whichis 50 mV maximum.

Options:

Remote Sensing: Provides regulation for main output within 2% of the nominal voltage. Single output units are available from 3.3 V up to 48.0 V in 0.1 V increments. Custom output cords and connectors are available upon request.

Approvals:

Safety:

IEC950 models, UL 1950 to CSA 22.2 #950, EN60950
IEC601 models, UL 601, C-UL to CSA 22.2 #601, EN60601.

CE Mark

Complies with EN5022, EN5011 Class B, and FCC part 15, Class B when tested with a resistive load, both conducted and radiated.
- Tested to comply with EN50082-1 including EN61000-4-2 EN61000-4-3, EN61000-4-4, EN61000-4-6, EN61000-4-11, EN61000-3-2 (PFC option).
Unit is eligible for CE Mark.